optimum frequency
英 [ˈɒptɪməm ˈfriːkwənsi]
美 [ˈɑːptɪməm ˈfriːkwənsi]
网络 最佳频率
双语例句
- Theoretical calculation and experimental study for the optimum frequency in ultrasonic liquid level determination
超声液位检测频率选择的理论计算和实验研究 - The optimum frequency of the signal source is hard to be determined by means of calculation since some of the materials are sensitive to the microwave with a certain frequency or very narrow frequency band.
由于有些材料对某个频率或极窄频带的微波特别敏感，信号源的最佳频率一般理论计算难以确定。 - Through the optimum searching, one may obtain the optimum frequency spacing, average damping ratio, tuning frequency ratio, and corresponding index representing the control effectiveness of MTMD.
通过最优搜寻可得MTMD的最优频率间隔、平均阻尼比、调谐频率比和相应的无量纲控制有效性指标。 - Simultaneously, it provides the method to determine the best pressure of header system and optimum frequency of variable frequency pump based on the special working condition.
同时，给出了在特定工况下，确定最佳母管压力和变频泵最佳频率的方法。 - Optimum frequency tuning is important in non-dispersive guided wave generation.
最优频率的选择对非频散波的产生至关重要。 - However, LT-TMD needs higher optimum tuning frequency ratio and lesser optimum damper ratio with reference to traditional TMD.
然而，LT&TMD比传统的TMD具有更大的最优调谐频率比和更小的最优阻尼比。 - Finally, experimental results show that manufacturing quality is higher when excited frequency is within above optimum frequency range, and vibration parameters are in good agreement with error model.
进行了变频振动下料试验，试验结果表明，在该变频范围内可获得良好的断面质量，且下料机构的运动参量与误差模型符合。 - Optimum frequency ratio of adjacent jet actuators is1 ∶ 1, and the bigger amplitude ratio can obviously improve control effect.
在所取算例中，相邻激励器频率最佳比为1∶1；大的幅值比可明显提高控制效果。 - Research results indicates: the frequency of ultrasonic wave has little influence on the demulsification. and the optimum frequency is determined as 21 kHz;
在试验的频率段范围内超声波频率对破乳的影响不是很明显，确定最佳频率为21kHz。 - In order to achieve the most effective results of TMD system applied in diminishing the vibrations, there exists an optimization problem such as the optimum frequency ratio and optimum damp ratio.
为了达到调频质量阻尼系统最佳减振效果，需要对系统的参数进行优化，即求出最优频率比和最优阻尼比。